|
INSTALLATION
●
ALWAYS READ INSTRUCTIONS PRIOR TO INSTALLATION
If your device/component is electrically powered, MAKE SURE it is
switched off with its battery removed. Clean the device/component with
water or mild alcohol if possible, to remove any unwanted dirt/
dust/grease for easy installation & achieve optimum results.
Kits are
all pre-cut as illustrated above, & varies in design for each brand &
model.
RACEshield
is extremely easy to install. All you need is :-
- Basic
soap &
bowl of plain
water (into a
mixture of 2ml : 1~2L ratio).
-
A spray bottle
if available.
-
Stiff plastic.
-
Lint free absorbent cloth.
- Watch the
installation video, & use the instructions below as reference.
WATCH THE INSTALLATION VIDEOS
STEP-BY-STEP INSTALLATION (FRONT SIDE)
STEP-BY-STEP INSTALLATION (REAR SIDE)
READ THE INSTALLATION INSTRUCTIONS
1. SOLUTION PREPARATION:-
Prepare a VERY MILD soap solution (2ml drop to 1L ratio) into a
bowl or spray bottle.
2. PEELING & HANDLING:-
Always keep your fingers wet with solution to avoid fingerprint
marks. Peel off the appropriate RACEshield
from its backing, & dip it into the solution, or spray solution onto the
adhesive side while peeling.
(TIPS:- There might be a matte protective layer of film above
RACEshield. This layer enhances &
reduces any damage that might be caused onto
RACEshield during transportation & handling. It also acts as a
layer to reduce dirt from gathering during installation. IF PRESENT, IT MUST BE
REMOVED BEFORE installation.)
3. INSTALLATION ONTO DEVICE:-
Slide RACEshield gently onto
the product, aligning it at the same time.
(Tips:- Spray onto device/component ONLY IF IT IS NOT ELECTRICALLY
POWERED. This provides easy adjustments & installation.)
4. SOLUTION REMOVAL:-
Start removing the excess solution/bubbles by gently pushing out
from the center towards the edges of RACEshield
with any firm plastic. A squeegue is recommended if available.
5. DRYING:-
Using a lint-free towel or similar cloth, soak up any excess
moisture by wiping AWAY FROM the RACEshield
edges.
(TIPS:- If you encounter edges that do not adhere, hold/press that
portion with your fingers/palms as human heat improves adhesion. A hair dryer at
COLD setting can be used to slowly blow dry it.)
|
