|
|
SUPPORT
● Installation
Motorcycle Preparation Before Sending In Your Motorcycle :-
-
A dirty motorcycle will
show its dirt below RACEshield.
Motorcycle must be washed thoroughly.
-
As
RACEshield offers superb optical clarity,
waxing (to remove hard stains, dirt, grime) is highly recommended.
Note :- We will reject installation should the motorcycle deemed to
dirty.
Installation information :-
-
Our installers will
prepare the surface with a mild wash solution to
reduce dust and/or dirt before
RACEshield is installed. During
installation, slip solution will be constantly applied to
reduce to amount of dust and/or dirt gathered due to static build up.
Slight dust and/or WILL be inevitable.
-
Duration of installation : Approximately 3~7hrs (Varies with each make of motorcycles)
-
Time & Location of installation :
To be scheduled after confirmation of sale. (distributor, certified
installer & dealers)
Note :- Weekends are
usually snapped up.
-
Recommendation
: We very highly recommend the motorcycle to be left
with us for a day for further curing.
After installation :-
To ensure best results, the
following is NOT RECOMMENDED after
RACEshield is installed.:-
-
Allow film to cure
and moisture to evaporate within the next 24 hours after
installation.
-
Ridding above
100kmh within the next 24 hours after installation.
-
Washed, jet washed
or waxed within the next 48 hours after installation.
This is to allow film to cure and moisture to evaporate. After the above
is adhered to, the motorcycle can be
ridden and taken care of as usual.
Recommended care :-
-
To achieve the highest level of
protection and appearance of
RACEshield, follow care and maintenance instructions
provided with your vehicle.
-
For best results to keep
your motorcycle &
RACEshield in pristine condition, we
recommend MAXIMA Spray & Shine. Cleans stubborn stains
easily & leaves a high gloss protection with its Carnauba wax in one
step!
|
